Kingston 4GB DDR3 1600 MHz RAM

Out Of Stock

Stock: Out Of Stock
Model: Kingston 4GB DDR3
Product id: 19349

Based on 0 reviews. - Write a review

Add to Cart

Buy Now Ask Question

Add to Wish List Compare this Product

* অনলাইনে প্রোডাক্ট অর্ডারের পূর্বে হেল্পলাইন থেকে স্টক এবং ডেলিভারী সর্ম্পকে সঠিকভাবে জেনে অর্ডার করার জন্য বিশেষভাবে অনুরোধ করা যাচ্ছে *

• Capacity- 4GB • 800MHz fCK for 1600Mb/sec/pin • 8 independent internal bank • CAS Latency: 11, 10, 9, 8, 7, 6

Kingston 4GB DDR3 1600 MHz RAM

This document describes ValueRAM's 512M x 64-bit (4GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers.

Specification:

JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 800MHz fCK for 1600Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 11, 10, 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

• PCB : Height 1.180” (30.00mm), single sided component

Quick Compare

Product Details
Product	Kingston 4GB DDR3 1600 MHz RAM	Adata 4GB DDR3 1333MHz Desktop Ram	KingSpec NE 128GB NVMe M.2 2280 PCIe SSD
Image
Price	0৳	~~1,900৳~~ 1,550৳	~~3,650৳~~ 3,300৳
Model	Kingston 4GB DDR3	Adata 4GB DDR3 1333MHz	NE-128
Brand	KINGSTON	ADATA	KingSpec
Availability	Out Of Stock	In Stock	In Stock
Rating	Based on 0 reviews.	Based on 0 reviews.	Based on 0 reviews.
Summary	Kingston 4GB DDR3 1600 MHz RAM This document describes ValueRAM's 512M x 64-bit (4GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers. Specification: JEDEC standard 1.5V (1.425V ~1.575V) Power Supply • VDDQ = 1.5V (1.425V ~ 1.575V) • 800MHz fCK for 1600Mb/sec/pin • 8 independent internal bank • Programmable CAS Latency: 11, 10, 9, 8, 7, 6 • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock • 8-bit pre-fetch • Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] • Bi-directional Differential Data Strobe • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) • On Die Termination using ODT pin • Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C • Asynchronous Reset • PCB : Height 1.180” (30.00mm), single sided component ..	Adata 4GB DDR3 1333MHz Desktop Ram The Adata 4GB DDR3 1333MHz Desktop Ram module is a 512Mx72 bits 4GB(4096MB) DDR3-1333(CL9)-9-9-24 SDRAM memory module. The SPD is programmed to JEDEC standard latency 1333Mbps timing of 9-9-9-24 at 1.35V. Adata 4GB DDR3 1333MHz module is composed of eight-teen 256Mx8 bits CMOS DDR3 SDRAMs in FBGA package and one 2Kbit EEPROM in 8pin TDFN package on a 240pin glass–epoxy printed circuit board. Adata 4GB DDR3 1333MHz module is a Dual In-line Memory Module and intended for mounting onto 240-pins edge connector sockets. Synchronous design allows precise cycle control with the use of system clock. Data I/O transactions are possible on both edges of DQS. Range of operating frequencies, programmable latencies and burst lengths allow the same device to be useful for a variety of high bandwidth, high-performance memory system applications. Adata 4GB DDR3 1333MHz Desktop Ram Review Purchased this for an older Biostar motherboard mATX. Was not sure it would match its predecessor memory of the same bandwidth and speed etc. But it did and now I have 8 gigs of solid working memory. Boosted system performance significantly. Would recommend! Good memory at a good price. Despite it's different look, it perfectly matched the other 4GB ADATA stick with heat spreader that I had, allowing me to easily upgrade my workstation to 8GB. Working at 1333MHz @ 9-9-9-24 with no issues. As other reviews already state, this RAM does its' job. The price is great, and despite being a lower frequency than other choices there isn't a performance difference. This is great RAM for cheap, I'd recommend it to anyone. Specifications Power supply (Normal): VDD & VDDQ = 1.35V (1.283V to 1.45V) Backward-compatible to VDD=+1.5V+-0.075V MRS Cycle with address key programs - CAS Latency (6,7,8,9) - Burst Length (BL):8 and 4 with Burst Chop(BC) Bi-directional, differential data strobe (DQS and /DQS) Differential clock input (CK, /CK) operation DLL aligns DQ and DQS transition with CK transition Double-data-rate architecture; two data transfers per clock cycle 8 independent internal bank Internal (self) calibration: Internal self calibration through ZQ pin (RZQ:240 ohm±1%) Auto refresh and self refresh Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE ≤ 95°C 8-bit pre-fetch. On Die Termination using ODT pin. On-board I2C temperature sensor with integrated serial presence-detect (SPD) EEPROM. EEPROM software write protect. Lead-free products are RoHS Compliant ..	SpecificationSSDCapacity(GB)128GBForm FactorM.2 2280Interface TypePCI-E Gen3 X4MTBF1 Million HoursSequential R/WRead Speed: 2400~2700MB/S· Write Speed: 1900~2000MB/SFlash Type3D TLCDimensionL80.0mmW22.0mmH2.1mm ±0.15mmOperating Temperature0℃--+70℃Storage Temperature-20℃--+75℃Warranty3 YearsKingSpec NE 128GB NVMe M.2 2280 PCIe SSDThe KingSpec NE 128GB NVMe M.2 2280 PCIe SSD comes with 128GB capacity. It offers fast and continuous read-write speeds to help you improve working efficiency, gaming experience, and graphics quality. The KingSpec NE comes with 5 layer graphene copper foil heat sink to make more excellent performance. This SSD features Exclusive 3D NAND Firmware Technology, which is a Strict selection of stable and high-performance 64-layer 3D NAND flash memory and high-performance main control chips, achieving enhanced performance and stability. KingSpec NE SSD comes with a High-level LDPC Debugging Mechanism, that ensures the accuracy of data transmission, protects data security, and extends the using life. The KingSpec NE 128GB NVMe M.2 2280 PCIe SSD has 3 years of warranty...